Dashboard not decoding

For the early roll-out of the Dashboard

Moderator: pa3weg

Dashboard not decoding

Postby wkautter » Fri Dec 06, 2013 5:14 pm

I've been able to decode two passes but nothing in the last few tries. I believe the signal is strong enough at least compared to the weak signal test recording. I can play the test recordings through Dashboard and get the decoded telemetry and messages. My setup is a ICOM 9100 using SATPC32 for doppler correction. I have the Monitor Signal checked and I can hear the signal through Dashboard so I would assume the software is getting the signal also. Not sure what else to try at this point. Any ideas?
wkautter
 
Posts: 1
Joined: Fri Dec 06, 2013 4:23 pm

Re: Dashboard not decoding

Postby g0mjw » Fri Dec 06, 2013 9:21 pm

The bandwidth is quite critical but assuming you have the signal centred, make sure you have turned off any DSP stuff, audio equalisation, notch filters, noise blankers etc.

Mike
g0mjw
 
Posts: 45
Joined: Tue Oct 08, 2013 7:30 am


Return to Dashboard Software questions, problems and bug reports

Who is online

Users browsing this forum: No registered users and 2 guests

cron