Dashboard not decoding

For the early roll-out of the Dashboard

Moderator: pa3weg

Dashboard not decoding

Postby wkautter » Fri Dec 06, 2013 5:14 pm

I've been able to decode two passes but nothing in the last few tries. I believe the signal is strong enough at least compared to the weak signal test recording. I can play the test recordings through Dashboard and get the decoded telemetry and messages. My setup is a ICOM 9100 using SATPC32 for doppler correction. I have the Monitor Signal checked and I can hear the signal through Dashboard so I would assume the software is getting the signal also. Not sure what else to try at this point. Any ideas?
Posts: 1
Joined: Fri Dec 06, 2013 4:23 pm

Re: Dashboard not decoding

Postby g0mjw » Fri Dec 06, 2013 9:21 pm

The bandwidth is quite critical but assuming you have the signal centred, make sure you have turned off any DSP stuff, audio equalisation, notch filters, noise blankers etc.

Posts: 45
Joined: Tue Oct 08, 2013 7:30 am

Return to Dashboard Software questions, problems and bug reports

Who is online

Users browsing this forum: No registered users and 1 guest